CoolBloC C31 DN 32 (1¼")

direct / unmixed
Field of application: for boiler charging, for modulating temperature heating
Recommended application range: up to 50 kW; 20 K up to 2150 l/h

Manufacturer:

PAW GmbH & Co. KG
Böcklerstr. 11 31789 Hameln
Germany
info@paw.eu

Skip to the end of the images gallery

Skip to the beginning of the images gallery

Technical data

Operating data

Max. operating temperature: 95 °C

Dial thermometer: 0 - 120 °C

Output: 50 kW

Max. operating pressure: 6 bar

Temperature difference: 20 K

Kvs value: 15.1

Min. operating temperature: 5 °C

Flow rate: 2150 l/h

Equipment

Check valves: 1 x 200 mm wc

Dial thermometer: 0 - 120 °C

Shut-off valves: Ball valves with handle

Opening pressure check valve: 200 mm wc

Number of check valves: 1

Dimensions

Height: 441 mm

Width: 250 mm

Nominal diameter: DN 32 (1¼")

Installation length: 400 mm

Connection generator: 1¼" int. thread

Connection consumer: 2" ext. thread, flat sealing

Centre distance: 125 mm

Materials

Valves and fittings: Brass

Gaskets: EPDM

Insulation: EPP

Description

Condensation-resistant valves and fittings: high-quality components to avoid condensation
Special pump with additional insulating element for the use in special ambient conditions, such as dewing or condensate formation
Thermal separation of the actuator (only C34 DN 25/32) and the mixing valve to avoid condensate formation
Sealing lips protected by the utility model in the insulation to reduce condensate formation

Downloads

Product information

Safety instructions
The installation and commissioning as well as the connection of electrical components require technical knowledge commensurate with a recognised vocational qualification as a fitter for plumbing, heating and air conditioning technology, or a profession requiring a comparable level of knowledge [specialist].
The following must be observed during installation and commissioning:
- relevant local and national regulations
- accident prevention regulations of the professional association
- instructions and safety instructions mentioned in these instructions.

CAUTION
Personal injury and damage to property!
The product must only be used in heating circuits filled with heating water according to VDI 2035 / Ö-Norm H 5195-1. The product must not be used in domestic water applications.

NOTICE
Material damage due to mineral oils!
Mineral oil products cause lasting damage to seals made of EPDM, whereby the sealant properties get lost. We do not assume liability nor provide warranty for damage to property resulting from sealants damaged in this way.
- It is imperative to avoid that the EPDM sealing elements of the unit get in contact with substances containing mineral oils.
- Use a lubricant based on silicone or polyalkylene and free from mineral oils, such as Unisilikon L250L and Syntheso Glep 1 of the Klüber company or a silicone spray.